Okay guys I've been trying to get my first untangle installation set up, and for the life of me despite everything looking like it's fine I cannot get any clients on the other side of a bridge to receive an IP from my router. I consider myself savvy enough with networking so I must just be missing something incredibly stupid or it's something I don't know about untangle. Here's the environment!
Cox cable modem -> ASUS RT-N66U router -> Thinkpad T42 (bridge mode) -> Netgear GS605 (have tried one other switch as well as direct connect to untangle)
The ASUS router is setup pretty much normal, DHCP, no fancy policies, etc.
The two NICs (have tried both USB NICs to see if one was the problem, but will only use one):
*Onboard Intel centrino gigabit (external)
*Cisco USB300M (http://support.linksys.com/en-us/sup...apters/USB300M) (internal)
*Sabrent USBG-G1000 (http://www.sabrent.com/category/networking/USB-G1000/) (internal)
I went through the wizard and kept all the defaults really. Below is how it looks:
http://imgur.com/a/IWBqr
I also flipped them around and tried USB for external and onboard for internal. Same issue though if I recall internet connectivity doesn't work then whereas it does with onboard for external. If it is both USB adapters, is there some kind of command that makes them work? Someone in this very forum stated the Cisco one works just fine so I am assuming they both do since the issue is the same. I've also swapped out cables and even tried a crossover cable from internal to switch. Anyway, let me know if I missed something.
Cox cable modem -> ASUS RT-N66U router -> Thinkpad T42 (bridge mode) -> Netgear GS605 (have tried one other switch as well as direct connect to untangle)
The ASUS router is setup pretty much normal, DHCP, no fancy policies, etc.
The two NICs (have tried both USB NICs to see if one was the problem, but will only use one):
*Onboard Intel centrino gigabit (external)
*Cisco USB300M (http://support.linksys.com/en-us/sup...apters/USB300M) (internal)
*Sabrent USBG-G1000 (http://www.sabrent.com/category/networking/USB-G1000/) (internal)
I went through the wizard and kept all the defaults really. Below is how it looks:
http://imgur.com/a/IWBqr
I also flipped them around and tried USB for external and onboard for internal. Same issue though if I recall internet connectivity doesn't work then whereas it does with onboard for external. If it is both USB adapters, is there some kind of command that makes them work? Someone in this very forum stated the Cisco one works just fine so I am assuming they both do since the issue is the same. I've also swapped out cables and even tried a crossover cable from internal to switch. Anyway, let me know if I missed something.