Hey everyone, new to Untangle here.
Every remote user is being disconnected from LogMeIn almost instantly, and sometimes after 10-30 seconds. It started when i installed Untangle. I am going to flip out.LMI Error.png
After authenticating it says i may now remote control and send steady state.
Config:
Cable Modem bridged to -> Untangle & Edgemarc (For Phone QOS)
Untangle Router Mode with DHCP On, DNS pointed to the Server w/ Active Directory running DNS.
Untangle -> Switch, Switch -> Server
I have searched the forums and tried a few of the things mentioned but most of the posts were old, to no avail.
I have run a ping -t to make sure the internet isn't being intermittent on the workstations and server. They are good.
The EndUsers here are anal about using LogMeIn, and from what i've read here, if it isn't working for you with UT, it can be a pain. Main problem is the UT is new so the bosses aren't happy about the unforseen side effects of having security.
I am fine bypassing whatever is needed to get LMI to have a steady connection for the users.
What kind of things can i try to narrow down my issue, and can anyone assist me in getting this going tomorrow morning? I don't mind skyping or PMing, i'll check back here too. Sorry to be a pain. :worship:
Every remote user is being disconnected from LogMeIn almost instantly, and sometimes after 10-30 seconds. It started when i installed Untangle. I am going to flip out.LMI Error.png
After authenticating it says i may now remote control and send steady state.
Config:
Cable Modem bridged to -> Untangle & Edgemarc (For Phone QOS)
Untangle Router Mode with DHCP On, DNS pointed to the Server w/ Active Directory running DNS.
Untangle -> Switch, Switch -> Server
I have searched the forums and tried a few of the things mentioned but most of the posts were old, to no avail.
I have run a ping -t to make sure the internet isn't being intermittent on the workstations and server. They are good.
The EndUsers here are anal about using LogMeIn, and from what i've read here, if it isn't working for you with UT, it can be a pain. Main problem is the UT is new so the bosses aren't happy about the unforseen side effects of having security.
I am fine bypassing whatever is needed to get LMI to have a steady connection for the users.
What kind of things can i try to narrow down my issue, and can anyone assist me in getting this going tomorrow morning? I don't mind skyping or PMing, i'll check back here too. Sorry to be a pain. :worship: