I have a HP DL380 G5 which has been running UT for a few years and suddenly one of the two NICs failed (both on the Motherboard)
A new MB was installed and UT saw there was a change but added the ports as eth3 and eth4 and will not activate them ie when you plug them into a hub or switch they do not respond or show as online.
Any idea on how to remove the eth3 and eth4 so i can get it to setup as eth1 & Eth2 again ?
A new MB was installed and UT saw there was a change but added the ports as eth3 and eth4 and will not activate them ie when you plug them into a hub or switch they do not respond or show as online.
Any idea on how to remove the eth3 and eth4 so i can get it to setup as eth1 & Eth2 again ?