I searched the forum but was unable to find an answer to my question
I just setup a new box with 64bit 10.1 lite version. It's my first experience with 10. I must say that I like a lot of the changes.
When Port Forwarding in V9 I was always able to setup multiple IP's in the "Source Address" field. V10.1 clears the field automatically when I try to do this.
Is there a work around for this??
An example would be forwarding Port 5900 for VNC and restricting what IP's have access so it's not just open to everyone.
I administer multiple UT boxes and want to be able to VNC to certain computers from any of the locations.
Thanks in advance for any help.
I just setup a new box with 64bit 10.1 lite version. It's my first experience with 10. I must say that I like a lot of the changes.
When Port Forwarding in V9 I was always able to setup multiple IP's in the "Source Address" field. V10.1 clears the field automatically when I try to do this.
Is there a work around for this??
An example would be forwarding Port 5900 for VNC and restricting what IP's have access so it's not just open to everyone.
I administer multiple UT boxes and want to be able to VNC to certain computers from any of the locations.
Thanks in advance for any help.