Until recently I have been using a Smoothwall VM behind an Actiontec c1000a with no issues. I have switched to Untangle (VM on the same host) and I am having a few issues... setup was simple and it looks like most everything is working, but for some reason I cant access the setup page on the Actiontec like I used to.
Here is my network:
LAN -> Untangle VM (router mode) -> Actiontec(router / DSL Modem) -> Internet
My LAN is on the 192.168.100.0 subnet while the Untangle WAN interface is on the 10.1.1.0 subnet... so I think I have whats referred to as a double NAT scenario, that correct?
Ultimately I want to setup the Actiontec in bridged mode, thats another issue that I will get into once I get this figured out.
The problem: I can ping 10.1.1.1 (the Actiontec LAN interface) just fine from the 192.168.100.0 subnet, but I cant get into it to configure via typical 80 and 443
What am I missing? Thanks!
Here is my network:
LAN -> Untangle VM (router mode) -> Actiontec(router / DSL Modem) -> Internet
My LAN is on the 192.168.100.0 subnet while the Untangle WAN interface is on the 10.1.1.0 subnet... so I think I have whats referred to as a double NAT scenario, that correct?
Ultimately I want to setup the Actiontec in bridged mode, thats another issue that I will get into once I get this figured out.
The problem: I can ping 10.1.1.1 (the Actiontec LAN interface) just fine from the 192.168.100.0 subnet, but I cant get into it to configure via typical 80 and 443
What am I missing? Thanks!
